At this point,  soak a soft cloth in water,  wring it out well to remove excess water and wipe it over the doors. Pay special attention to the dirtiest spots, without scratching, because applying force or rubbing too much risks damaging the wall units. After a few minutes, thanks to this solution, the dirt disappears.  Once the desired result has been obtained, dry the cabinets  with a clean cloth.

Ethyl alcohol, the miracle solution to use at home for cleaning

Another method for cleaning greasy and dirty cabinets involves the use of ethyl alcohol, which can only be used on wooden surfaces and not on other materials, which instead of cleaning, can ruin the furniture. Alcohol can be used to prepare an excellent cleaner, which is kept in a spray bottle of at least half a litre.  This detergent can be used at any time,  for example right after finishing cooking and washing dishes. The detergent in question allows you to immediately remove stains, grease and vapours and always keep the kitchen sanitised and shiny.

To prepare the mixture, pour warm water into the bottle, then add a glass of alcohol and  mix vigorously.  Once this is done, spray the solution directly onto the dirty door and rub it with a damp, well-wrung cloth. It is better if the cloth is warm. When you wipe the damp cloth you will notice streaks, but don’t worry, when the wall unit is clean it will be dried with another cloth and here you have the more than surprising result.

The best remedy, the ally of housewives: baking soda

To conclude, the remedy par excellence requires the use of baking soda, which removes the dirt that settles on greasy and dirty cupboards, but not only that.  Baking soda is used in the kitchen to solve many problems.

In this case,  there is no recommended dosage:  you can dilute two or three tablespoons in a container that is not too full of water. The important thing is that there is no baking soda left at the bottom, because when you wet the cloth to clean the cabinets you run the risk of picking up too much of the product. This could have an abrasive effect and therefore ruin the surface. Once finished,  dry everything well again using a soft cloth  and that’s it.